Version 3.44
------------------------------------------------------------------
- Saving to file can now be started and stopped by 2 reserved trigger codes. The
  (8-bit) codes are defined in the CFG file. Trigger edges unlock or lock the
  "pause save" button, manual control of the pause button overrides the trigger pulses.
- The CFG file is expanded with "system" lines at the top. Please insert the proper
  motherboard number (5 or 6, see serial number). A wrong motherboard number in the
  CFG file will cause a mix-up between Resp, Erg1 and Erg2 channels.
------------------------------------------------------------------


Version 3.40
------------------------------------------------------------------
- Selectable screen lengths for monopolar, bipolar, Aux and AIB charts,
  1, 2, 4, 8 or 32 seconds. All charts have the same time base.
------------------------------------------------------------------


Version 3.35
------------------------------------------------------------------
- The trigger display has been moved to the monopolar display page,
- "start save" is replaced by "start file"
- Saving always begins in "paused" mode to allow user to enter local information well
  before the actual experiment starts (saving is not started immediately anymore after
  the filename is entered), "start file" and "pause save" are moved to the right sidebar
- On-line ERP result calculation for two selected channels (this will be expanded to more
  channels in the future)
- Screen also scrolls in 16 kHz speedmode (with 1 sec timebase)
------------------------------------------------------------------