Version 5.09 (USB) and 4.09 (PCI)
-----------------------------------------------------------------
- Path for BDF datafiles is stored in CFG
- Filter bug for GSR2 sensor repaired


Version 5.03 (USB) and 4.08 (PCI)
-----------------------------------------------------------------
- In the .CFG file an extra setting has been introduced: "ElecGain".
  When the ActiveTwo system has been equipped with modules with a gain of 31,25nV/bit then set "ElecGain=0" (standard)
  When the ActiveTwo system has been equipped with modules with a gain of   125nV/bit then set "ElecGain=1" (BSM applications)
- Warning "for research only" added


Version 5.02
-----------------------------------------------------------------
- Version only compatable with USB2 interface
- file limit bug corrected (program could run into 2GB Windows file limit before internal limit triggered
  proper closing of the file)
- Window resized to dimensions available in Windows XP (smaller height than classic look)
- handling of arrays changed for more efficiency


Version 4.03
------------------------------------------------------------------
- Source code upgraded to LabVIEW 7.0 (RunTimeEngine 7.0 or higher is needed to run ActiView versions of 4.0 or higher).
- Free channel selections now work with SHFT and CTRL, according to the standard Windows convention.
- Reset of LP filters at every screen start removed, processor load by filters decreased.
- Lowpass filter added to online average.
------------------------------------------------------------------


Version 3.44
------------------------------------------------------------------
- Saving to file can now be started and stopped by 2 reserved trigger codes. The
  (8-bit) codes are defined in the CFG file. Trigger edges unlock or lock the
  "pause save" button, manual control of the pause button overrides the trigger pulses.
- The CFG file is expanded with "system" lines at the top. Please insert the proper
  motherboard number (5 or 6, see serial number). A wrong motherboard number in the
  CFG file will cause a mix-up between Resp, Erg1 and Erg2 channels.
------------------------------------------------------------------


Version 3.40
------------------------------------------------------------------
- Selectable screen lengths for monopolar, bipolar, Aux and AIB charts,
  1, 2, 4, 8 or 32 seconds. All charts have the same time base.
------------------------------------------------------------------


Version 3.35
------------------------------------------------------------------
- The trigger display has been moved to the monopolar display page.
- "start save" is replaced by "start file".
- Saving always begins in "paused" mode to allow user to enter local information well
  before the actual experiment starts (saving is not started immediately anymore after
  the filename is entered), "start file" and "pause save" are moved to the right sidebar.
- On-line ERP result calculation for two selected channels (this will be expanded to more
  channels in the future).
- Screen also scrolls in 16 kHz speedmode (with 1 sec timebase).
------------------------------------------------------------------